The Wi-Fi indicator blinks.The next screen is displayed for approximately 2 seconds, and then the Wi-Fi indicator lights.When the message appears, press [OK] to close the screen and start the procedure again from Step 5.If after retrying the access point it cannot be connected, see the following:"Onscreen Messages"11Wait until the machine sets the IP address automatically (approx. 2 min).If you want to set the IP address manually, see the following."Setting the IPv4 Address""Setting the IPv6 Address"㻡㻠㻞㻌㻛㻌㻥㻢㻠Downloaded from ManualsPrinter.com Manuals