Recording1063 Special Recording ModesAvailable Intervals** In the camcorder’s menu, seconds are indicated by [sec] and minutes areindicated by [min].Activating Interval Recording Mode and Recording1 Open the [Special Rec] submenu.[J Other Functions] [Special Rec]2 Select [Interval Rec] and then press SET.• [INT STBY] appears at the top of the screen (with [INT] flashing).3 Press the START/STOP button to begin recording.• The camcorder automatically records the set number of frames atthe set interval.• The tally lamps illuminate.• [INT STBY] changes to [N INT REC] while recording frames and[N INT STBY] while between intervals.4 Press the START/STOP button again to stop recording.• All of the recorded frames are joined together into one clip.• The tally lamps go out and [INT STBY] appears at the top of thescreen (with [INT] flashing).NOTES• You can use only one special recording mode at a time.• While recording, you cannot change the interval or number of frames.• Some frames at the point the recording was stopped may be recordedand added to the end of the clip.• Interval recording mode will be deactivated if the special recordingmode is changed or turned off. It will be deactivated also if you changethe [J Other Functions] [Bit Rate/Resolution] or [Frame Rate]setting.• The time code advances by the number of frames recorded. If therunning mode of the time code (0 85) is set to [Free Run] or the timecode is input from an external source (b only), the running modewill switch to [Rec Run] during special recording mode. When specialrecording mode is deactivated, the running mode will return to itsprevious setting.• b During special recording mode, the time code signal will notbe output from the TIME CODE terminal or HD/SD SDI terminal.1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec 9 sec10 sec 15 sec 20 sec 30 sec 40 sec 50 sec 1 min 2 min 3 min4 min 5 min 6 min 7 min 8 min 9 min 10 min[J Other Functions][ Special Rec][Off]COPY
