Canon PIXUS iP8600 Service Manual

Also see for iP8500 - PIXMA Color Inkjet Printer: Supplementary guide Easy Setup instructions Quick start guide Quick start guide Service manual

Contents

Canon PIXUS iP8600 Service Manual Manual pdf 8 page image

2. LIST OF ERROR DISPLAY / INDICATIONErrors are indicated by the LED, and warnings are displayed on the monitor of the computer connected to the printer.2-1. Operator Call Errors (by LED Blinking in Orange)*1: Only for models not supporting CD-R printingLED blinkingin orange Error [Error code] Solution Remarks2 times No paper. (ASF) [1000] Set the paper in the ASF, and press the Resume/Cancelbutton.No CD-R tray. [1001] Set the CD-R tray, and press the Resume/Cancel button.No paper in the cassette. [1003](No paper in the front paper feed cassette.)Set the paper in the cassette, and press the Resume/Cancelbutton.3 times Paper jam. [1300] Remove the jammed paper, and press the Resume/Cancelbutton.Paper jam in the under guide. [1304]Paper jam in the rear guide. [1303]Front door closed. [1250] Open the paper output tray.4 times No ink. [1601 / 1611 / 1612 / 1613 / 1614 /1615 / 1634 / 1635]Replace the empty ink tank(s), or press the Resume/Cancelbutton.Pressing theResume/Cancel buttonwill exit the error withoutink tank replacement,however, ink may run outduring printing.5 times - The print head is not installed. [1401]- The print head is not properly installed(EEPROM data of the print head is faulty).[1403 / 1405]- Non-supported print head is installed. [1485]Install the print head properly, and close the access cover.Or, with the print head installed, turn the printer off and on.6 times Inner cover open. [1841] *1 Close the inner cover, and press the Resume/Cancel button.Inner cover open (during printing on paper).[1846] *1Close the inner cover, and press the Resume/Cancel button.CD-R tray feeder closed (during CD-Rprinting). [1850 / 1855]Open the CD-R tray feeder, set the CD-R tray properly, andpress the Resume/Cancel button.CD-R tray feeder open (during printing topaper). [1851 / 1856]Close the CD-R tray feeder, and press the Resume/Cancelbutton.7 times No CD-R or DVD-R. [1002] After setting a CD-R or DVD-R in the tray, set the tray in thetray guide, and press the Resume/Cancel button.8 times Warning: The waste ink absorber is almost full(approx. 95% of the maximum capacity). [1700]Pressing the Resume/Cancel button will exit the error, andenable printing.In repair servicing, replace the bottom case unit (QM2-1583), or the ink absorbers (QC1-5381 / 5382 / 5383 / 5384 /5385 / 5386 / 5387 / 5388 / 5389 / 5390).The service call error,indicating the waste inkabsorber is full, is likely tooccur soon.9 times The connected digital camera or digital videocamera does not support Camera DirectPrinting. [2001]After removing the cable between the camera and the printer,press the Resume/Cancel button, and re-connect the cable.10 times Automatic duplex printing cannot be performed(paper size not supported). [1310]Press the Resume/Cancel button to eject the paper beingused at error occurrence. Printing will resume from on thefront side of the next page.Data which was to beprinted on the back side ofpaper at error occurrence isskipped (not printed).11 times Failed in automatic print head alignment. [2500] Press the Resume/Cancel button, and after confirming thefollowing, perform print head alignment again:- Set an appropriate type and size of paper (plain paper, A4or letter).- Check that the nozzle check pattern is properly printed (allink ejected, no faint printing).- Protect the paper output slot from exposure to excessivelight.Access cover open. [1200] Close the access cover.1 - 3