72 TroubleshootingENGLISHRe-setting the machineThe admin password set to the machine was forgotten“Communication with the Card Slotfailed” is displayed during setup(Continued)z Change the workgroup name to “WORKGROUP” following the procedurebelow.(1) Right-click My Computer, then select Properties.(2) Select the Computer Name tab, then click Change.(3) Change the workgroup name to “WORKGROUP”, then click OK.If these do not resolve the problem, click Skip to complete the setup without thenetwork setup of the Card Slot. To mount the Card Slot as the network driveafter setup, refer to the Network Guide on-screen manual.“The Card Slot is already mapped asNetwork Drive to this computer” isdisplayed during setupThe Card Slot is already available. Click OK to close the dialog, then click Nexton the Network Setup of the Card Slot dialog box.“Cannot map any more drives, becauseall the drive letters are assigned” isdisplayed during setupMake a drive letter manually, and try the network setup of the Card Slot again.Problem Possible Cause and MeasuresRe-setting the machine Set the machine setting to the default and set up the machine again. For details,see “Printing and Initializing Network Settings” on page 75. For setupprocedures, see “Confirming the Setup Environment” on page 20.Problem Possible Cause and MeasuresThe admin password was forgotten Set the machine setting to the default. All settings previously set will be lost afterinitialization. Set up the machine again to use it. For details, see “Initializingusing the Operation Panel” in “Printing and Initializing Network Settings” onpage 75.Problem Possible Cause and Measures
