Canon PIXMA MP600 Quick Start Manual

Also see for PIXMA MP600: Supplementary guide Brochure Start here Quick start guide Quick start guide

Contents

Canon PIXMA MP600 Quick Start Manual Manual pdf 93 page image

89Troubleshooting*1 To resume printing, you can also press the OK button on the machine instead of selectingContinue on the camera.*2 The ink absorber absorbs ink used during cleaning, for example. If this message appears, youwill need to call for servicing to replace the absorber and to check the machine for properoperation.Cannot Print Properly from a Photo Index Sheet“Waste tank (ink absorber*2 ) full”/“ink absorber *2 full”This error message indicates that the ink absorber is nearly full.The machine has a built-in ink absorber to hold the ink used during Print HeadCleaning, for example.You can continue printing by selecting Continue*1 on the display on yourcamera.However, because printing is disabled once the ink absorber becomescompletely full and until the ink absorber is replaced, you are recommended tocontact a Canon service representative as early as possible. (You will need toreplace a particular part of the machine.)“No ink” An ink tank is not installed properly, or is out of ink.Confirm the error message displayed on the LCD and take the appropriateaction to resolve the error. For details, see “Error Message Is Displayed on theLCD” on page 68.“Ink Error” An ink tank that was once empty is installed.Replace the ink tank and close the Scanning Unit (Printer Cover).Printing with an ink tank that was once empty may damage the machine.If you want to continue printing in this condition, you need to release the functionfor detecting the remaining ink level. Press and hold the Stop/Reset button forat least 5 seconds, and then release it.* With this operation, releasing the function for detecting the remaining inklevel is memorized. Please be advised that Canon shall not be liable for anymachine malfunction or damage caused by refilled ink tanks.See “Replacing an Ink Tank” on page 46.“Hardware Error” An ink tank error has occurred. Replace the ink tank. See “Replacing an InkTank” on page 46.“Printer error” An error requiring servicing may have occurred. (Machine’s POWER lampflashes green and ALARM lamp flashes orange alternately.)Disconnect the cable between the machine and the camera, turn off themachine, and unplug the power cord of the machine from the power supply.After a while, plug the power cord of the machine back in, turn on the machine,and then reconnect the camera to the machine.If the same error occurs, contact your Canon service representative.Cause Action“Failed to scan Photo Index Sheet.” isdisplayed. z Make sure the Photo Index Sheet is set in the correct position and orientationon the Platen Glass.z Make sure the Platen Glass and the Photo Index Sheet are not dirty.z Make sure all required circles on the Photo Index Sheet are filled in. If thefilled circles on the sheet are not marked dark enough, the machine may notread the settings.Refer to “Printing by Using the Photo Index Sheet” in “Using Other UsefulPrinting Functions” of the User’s Guide on-screen manual.Error Message On Camera Action