Recording Still Images on a Memory Card f_l []You can record still images with the PHOTObuttoncamcorder, from a tape in the camcorder Card access([_ 115) or from devices connected via the indicator __,_DV terminal or AV terminal (C_ 116). _.../__O Do not turn off the camcorder, disconnect the power source, open the memorcard cover or remove the memory card while the card access indicator isflashing. Doing so could result in data damage.O When you are using a SD Memory Card, make sure that the protect switch isset to allow recording.O Make sure to insert a memory card with enough remaining capacity.O The camcorder shuts off when you do not operate it for 5 minutes to savepower. " OAUTO POWEROFF" appears 20 seconds before shutoff. Tocontinue recording, turn the POWERswitch to OFF and then back to CAMERA.OWe recommend saving the still images and movies on the memory card to acomputer regularly.Record iBg _i _h _h ¢_ mc_rd1. Set the camcorder to CARD CAMERA mode.A white focusing frame appears in the center of the screen. The camcorder will focus onthe subject in the center of the screen. To change the focusing point, see Selecting theFocusing Point ([[_ 117).2. Press the PHOTO button halfway. _• 0 and focusing frame turn green when focus is adjusted. The _.__\_:--_beep sounds twice. The picture may appear out of focus for amoment while the camcorder is focusing.• Focus can be adjusted manually with the focus ring when thePHOTO button is pressed halfway.• Exposure is locked.• When you pressthe PHOTObutton on the wireless controller, recording starts immediately.300113