CHAPTER 8 INSTALLATIONCOPYRIGHT © 1999 CANON INC. CANON NP6320 REV.0 DEC. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON) 8-7D. Adding TonerWorkRemove the door switch actuator.Disengage the developing assembly, andslide it until it stops.Shake the toner cartridge well.Open the developing assembly lid, and fit theboss on the rear end of the toner cartridgeinto the hole of the plate on the rear end ofthe developing assembly; thereafter, pull thetoner cartridge to the front somewhat so thatit comes into contact with the boss found onthe left side of the front.Hold the toner cartridge, and pull on the sealto the front until it stops.Tap lightly on the top of the toner cartridgeuntil all toner has fallen into the developingassembly.Remove the toner cartridge, and keep it in anempty box.Close the developing assembly lid, and slidethe assembly inside until it stops.Turn the developing assembly lever clock-wise to engage it.Close the front cover.Set a blank sheet of paper (A3/11"×17") onthe copyboard after the Copy Start key goesgreen, and make six to ten copies.RemarksThe operation causes the toner inside thedeveloping assembly to be stirred.Step1234567891011
