Canon MX720 Series Online Manual

Also see for MX720 Series: Online manual Setup guide Online manual Online manual Setup

Contents

Canon MX720 Series Online Manual Manual pdf 30 page image

Cannot Use the Machine on Replacing an Access Point orChanging Its settingsWhen you replace an access point, perform network setup of the machine again.To perform network setup again, access our web site through the Internet and download the latestMiniMasterSetup for your model.If the problem is not resolved, see below.Cannot Communicate with the Machine After Applying MAC/IP Address Filtering or Entering aWEP/WPA/WPA2 Key to the Access PointWhen Encryption Is Enabled, Cannot Communicate With the Machine After the Encryption Type WasSwitched on the Access PointCannot Communicate with the Machine After Applying MAC/IP Address Filteringor Entering a WEP/WPA/WPA2 Key to the Access Point• Check 1: Confirm the access point setting.Refer to the instruction manual provided with the access point or contact its manufacturer to confirmthe access point setting. Make sure that the computer and the access point can communicate witheach other under this setting.• Check 2: If you are performing MAC address filtering or IP address filtering at theaccess point, confirm that the MAC address or IP address for both the computer orthe network device and the printer are registered.• Check 3: If you are using a WEP/WPA/WPA2 key, make sure that the key for thecomputer or the network device and the printer matches that set to the access point.Besides the WEP key itself, the key length, key format, the key ID to use, and the authenticationmethod must match among the machine, the access point, and the computer.Normally, select Auto for the authentication method. If you want to specify the method manually,select Open System or Shared Key according to the setting of the access point.How to Set a WEP/WPA/WPA2 KeyWhen Encryption Is Enabled, Cannot Communicate With the Machine After theEncryption Type Was Switched on the Access PointIf the printer cannot communicate with the computer after the encryption type of the printer was switched,make sure that encryption types for the computer and the access point matches that set to the printer.Cannot Communicate with the Machine After Applying MAC/IP Address Filtering or Entering aWEP/WPA/WPA2 Key to the Access Point