Canon Finisher-T1 Service Manual

Also see for Finisher-T1: Service manual Service manual Portable manual

Contents

Canon Finisher-T1 Service Manual Manual pdf 97 page image

Chapter 33-35Hold the snap fastener at the base whenunfastening because the sensor flag arm can breakeasily. When fastening, insert the boss of the sensorflag snap fastener in the hole on the processing trayside.F-3-1352) Remove the stack delivery roller front side E ring[1], gear [2], parallel pin [3], E ring [4], washer [5],and bearing [6].The parallel pin [3] drops when the gear [2] isremoved. Be careful not to loose it.F-3-1363) Remove all finisher controller PCB connectors[1]and remove the harness from two clamp [2].4) Remove four screws [3] and remove the finishercontroller PCB [4].F-3-1375) Release the claw [1] of the stack delivery roller rearside clutch [2] and remove the clutch [2].6) Remove the E ring [3], washer [4], and bearing [5]and remove the stack delivery roller.F-3-1387) Disconnect two connectors [1] and remove harnessfrom the clamp and edge saddle [2].8) Remove two screws [3] and pull out the processingtray [4] in the paper delivery direction.When removing parts inside the processing tray,be careful not to exert force on the aligning plate(front/rear) or the rear end stopper plate.[1][2][3][6][5][4][1][2] [3][3] [3][2][1] [4][2][2][3] [4] [5] [1]