Canon Finisher-T1 Service Manual

Also see for Finisher-T1: Service manual Service manual Portable manual

Contents

Canon Finisher-T1 Service Manual Manual pdf 170 page image

Chapter 55-105.3.11 E584 0009-2692T-5-145.3.12 Temporary Functional Limit 0009-26931. OverviewThe machine has a feature to temporarily enter the limited operation mode to perform only paper delivery, when anerror is encountered. The machine can continue to operate in this limited mode until the error is removed.In the limited operation mode, stapling, alignment, and punching (only applicable when equipped with optionalpuncher unit) are not performed, while the inlet sensor (PI103), escape tray path sensor (PI118), and feed path sensor(PI104) remain enabled to detect any jam.2. Operation1) When the host machine has started up, use service mode or user mode as follows:1-a) Service ModeSet '1' for the following: SORTER>OPTION>MD-SPRTN.1-b) User ModePress [limit function mode]; when a Confirmation screen has appeared, press [yes].3) Turn off and then on the main power switch of the host machine.3. Communication with the Host Machine1) When the main power switch is turned on, the DC controller PCB will communicate to the main controller PCBthat a functional limit has been imposed. The control panel will indicate that a functional limit has been imposedon the finisher.2) The DC controller PCB backs up information on the functional limit.3) Each time pickup occurs, the main controller PCB communicates the presence of a functional limit to the DCcontroller PCB.4) The DC controller PCB executes control only on delivery operation.Code Detail ErrorDescriptionDetection timingE584 8001 Stack ejectionmotor (M102)/Shutter open/close clutch(CL101)/Shutter homeposition sensor(PI113)/Stackejection lowerroller clutch(CL102)The stapler does not leave the shutterhome position when the stack ejectionmotor has been driven for 3 seconds.0002 The stapler does not return to the shutterhome position when the stack ejectionmotor has been driven for 3 seconds.