Canon FAX-L350 Service Manual

Also see for FAX-L350: Simplified guide Service manual

Contents

Canon FAX-L350 Service Manual Manual pdf 149 page image

3-38FAX-L350 Chapter 3: Maintenance and Service5.2.5 New SSSWs/parameters added to this model#1 SSSW (service soft switch setting)SW01 (service soft switch 01: error management)Bit Function 1 00 Service error code Output Not output1 Error dump list Output Not output2 Not used3 Copy function No Yes4 (New) ##300 series service error code Output Not output5 Not used6 Data & Time setting restriction Setting possible Setting restricted7 User setting restriction Setting possible Setting restricted[Bit 4]Even when Bit0 is set to “NOT OUTPUT”, you can select whether or not to output ##300 seriesService Error Codes, caused by hardware malfunction.When “OUTPUT” is selected, ##300 series Service Error Codes are displayed and included in reports.When “NOT OUTPUT” is selected, no Service Error Codes are displayed.#1 SSSW (service soft switch setting)SW05 (service soft switch 05: standard function settings)Bit Function 1 00 Not used1 Not used2 Not used3 Send DIS signal bits 33 and over No Yes4 Recording paper length availability A4 size Abiitrary sizedeciared in DIS signal5 (New) Declare LTR/LGL in DIS signal No Yes6 Not used7 Not used[Bit 5]Select whether to declare LTR or LGL in DIS signal when the LTR or LGL recording paper is used.The recording paper is selected according to the setting of #7 printer SW04 bit 0.#1 SSSW (service soft switch setting)SW15 (service soft switch 15: Dial inn FAX/TEL switching function setting)Bit Function 1 00 Not used1 Not used2 Not used3 Not used4 Not used5 Not used6 (New) Detect continuous signal at Yes NoFAX/TEL switching7 Not used[Bit 6]You may enable or disable detection of ROT continuous signal for FAX/TEL switching.Normally, only ROT intermittent signals are detected for FAX/TEL switching. If you need to detectboth in view of exchange specifications,select “1” to enable detection.