n Installing and using printer driversIn order to use a BJC-55 Series Printer, you must install the correctprinter driver on your computer. This section explains the printerdrivers.Printer drivers for Windows 98, Windows 95, Windows 2000 and MacOS 8.5/Mac OS 9 (If you are using an iMac, you must use Mac OS 8.1or later.) are provided with the printer. For installation instructions, seeGetting Started or the Windows Printer Driver Guide or MacintoshPrinter Driver Guide.The following printer driver is also provided on the Setup Software &Reference Guide CD-ROM:• Printer driver for Windows CE.Before you install this printer driver, read the Readme.txt file in theWinCE\Printer\Disk1 folder on the Setup Software & Reference GuideCD-ROM.n Setting up the IrDA wireless interfaceIf you have a computer or PDA with an infra-red port for wireless datatransmission, you can set up a cordless connection with the printer. Youcan use the IrDA method to effect infrared data transmission.Before you can set up an infra-red connection with the printer, you mustperform several settings on the computer. Make sure that you read thesection below before you set up the connection.33Chapter 2 Setting Up the Printer2USB IrDA (Infra-red) CommentWindows 95 No Version 1.0 In order to use an infra-redconnection, you will need aMicrosoft infrared port driverversion 2.0.Windows 98/ Yes Version 1.1 If you are using Windows 2000,Windows the BJ Status Monitor feature is2000/ not available.Windows CEMac OS Yes No
