Canon AK1 Service Manual

Also see for AK1: Operation guide

Contents

Canon AK1 Service Manual Manual pdf 66 page image

4. Write the new adjustment value on the service label.• ADJ-C15. Exit service mode.Cassette Left Edge Margin Adjustment (2nd Side: SoftwareAdjustment)1. Execute duplex printing from the cassette, and check that the left edge margin on the 2nd side is within 2.5 +/- 2.0mm(in the case of LTR/LGL: 4.2 +/- 2.0 mm).Feeding directionof paperL1image2. If the margin is not within the range, change the left edge margin adjustment value for the 2nd side of the cassette.As the value of COPIER > ADJUST > FEED-ADJ > ADJ-C1RE in service mode is incremented by 1, the left edge margin isincreased by 0.1mm. (The image moves to the right.)3. Execute duplex printing from the cassette, and check that the left edge margin is within 2.5 +/- 2.0mm.4. Write the new adjustment value on the service label.• ADJ-C1RE5. Exit service mode.Leading Edge Margin Adjustment (1st Side of Plain Paper)1. Copy from the cassette, and check that the leading edge margin is L1 = 4.0 +1.5/-1.0mm. If the margin is not withinthe range, execute the adjustment by following the procedure below.L1imageFeeding directionof paperIn Case of Out of Range2. Select service mode > COPIER > ADJUST > FEED-ADJ > REGIST.3. Make adjustment by changing the setting value. (As the setting value is incremented by 1, the leading edge marginis increased by 0.1 mm: the image moves to the trailing edge side).4. Write the new adjustment value on the service label.• REGIST5. Adjustment61