10 -20Test MenuWhen you scan the Test Menu On code, then scan a programming code in this manual, the scan engine displays the content of aprogramming code. The programming function will still occur, but in addition, the content of that programming code is output to theterminal.Note: This feature should not be used during normal scan engine operation.On* OffResetting the Factory DefaultsThis selection erases all your settings and resets the scan engine to the original factory defaults.It also disables all plugins.If you aren’t sure what programming options are in your scan engine, or you’ve changed some options and want to restore the scanengine to factory default settings, first scan the Remove Custom Defaults bar code, then scan Activate Defaults. This resets the scanengine to the factory default settings.Remove Custom DefaultsActivate DefaultApplication Plug-Ins (Apps)Any apps that you are using can be turned off or on by scanning the following bar codes. Apps are stored in groups: Decoding, andFormatting. You can enable and disable these groups of apps by scanning that group’s On or Off bar code below. You can also scan theList Apps bar code to output a list of all your apps.[Decoding Apps On]Decoding Apps Off[Formatting Apps On]Formatting Apps OffList AppsNote: You must reset your device in order for the apps setting to take effect.!
