Menu
Can-Am Commander Electric LSV Operator's Manual
                                                                                                                  | |
Contents
| 
MULTIFUNCTION GAUGE (ANALOG/DIGITAL)MESSAGE DESCRIPTIONBRAKE Message displayed when the brakes are applied continuously for15 seconds and vehicle speed is over 5 km/h (3 MPH).SEAT BELTWhen the seat belt is not buckled and the vehicle speed is less than10 km/h (6 MPH), the message is displayed and the pilot lamp willbe lit.ENGINELIMITATIONENGAGED FASTENSEAT BELTWhen the seat belt is not buckled and the vehicle speed is above10 km/h (6 MPH), the message is displayed and the pilot lamp willflash. The motor torque is limited and the vehicle maximum speedis approximately 15 km/h (9 MPH).ECO MODE ACTIVE Displayed when the ECO button is pressed.DIFFERENTIALLOCK Displayed when differential lock button is pressed8) Multifunction DisplayThe vehicle speed, the motor currentand the motor RPM can be displayed.Refer to MODE (M) BUTTON in thissection.9) Battery State of ChargeBar graph that continuously indicatesthe level of energy left in the batteries.10) Secondary Digital DisplayDisplays useful real time information tothe rider. For display function informa-tions, refer toSET (S) BUTTON.11) Drive Mode Position IndicatorDisplays the selected mode position.12) Motor Temperature IndicatorBar graph that continuously indicatesthe motor housing temperature.13) Numerical DisplayThe vehicle speed or the motor poweroutput can be displayed. ReferMODE(M) BUTTON.14) 2WD/4WD IndicatorWhen this indicator is ON, the 4WDsystem is activated.Gauge SetupSetting Metric/Imperial UnitsGo see a Can-Am dealer for adjust-ments.Setting Clock1. Press MODE (M) button to selectclock display.2. Push and hold MODE (M) button forthree seconds.3. Press MODE (M) button to select12:00 AM PM or 24:00 time base.4. If 12:00 AM PM time base is se-lected, A or P flashes. Press MODE(M) button to select A (AM) or P(PM).5. Press SET (S) button to changehours.6. Press MODE (M) button to switch tominutes (minutes flash).7. Press SET (S) button to change min-utes.8. Press MODE (M) button.Setting LanguageThe gauge display language can bechanged. Refer to an authorizedCan-Am dealer for language availabilityand setup the gauge to your prefer-ence._______________ 51 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved