OneStart

Menu

Campbell UT20 Product Manual

Also see for UT20: Instruction manualProduct manualInstruction manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Contents
  1. limited warranty
  2. Table Of Contents
  3. Table Of Contents
  4. Introduction
  5. Initial Inspection
  6. Siting and Exposure
  7. Temperature and Relative Humidity
  8. Solar Radiation
  9. Overview
  10. Specifications
  11. UT20/UT30 Tower Installation
  12. Tower Base Installation
  13. B18 Base installation
  14. RFM18 Base Installation
  15. RFM18 base dimensions
  16. Guy Anchor Installation
  17. UTDK duckbill guy anchor being driven into the ground
  18. Tower Assembly
  19. UT20/30 lightning rod and mounting bracket
  20. UTGND Tower Grounding Kit
  21. Attaching the Lightning Rod
  22. Crossarms and Mounting Brackets
  23. CMB200 Crossarm Brace Kit
  24. Assembly
  25. Bracket selection
Campbell UT20 Product Manual Manual pdf 27 page image
UT20 and UT30 Universal Towers21FIGURE 7-19. CMB200 components7.2.2.2 Assembly1. Consult FIGURE 7-20 and TABLE 7-2 to determine which brackets areneeded at either end of the brace to attach it to the crossarm and tower.The figure also indicates what orientation is needed when the smallbracket is used.Each bracket has a long tab and short tab where the bolts areattached. The brace arm must be attached to the end with the longtab.2. Attach one end of the brace arm to the tower below the crossarm. Leavethe bolts finger-tight.3. Lift the free end of the brace arm to the crossarm and attach it to thecrossarm. Again, only finger-tighten the bolts.4. Adjust the position of the brace arm as needed.5. Fully tighten the two bolts directly connected to the brace arm, and thentighten the remaining two bolts to clamp the brace arm to the tower.NOTE
/ 29
Related manuals for Campbell UT20
Campbell UT20 Product Manual first page preview
Campbell UT20 Product Manual
Campbell UT6 Product Manual first page preview
Campbell UT6 Product Manual
Campbell UT10 Instruction Manual first page preview
Campbell UT10 Instruction Manual
This manual is suitable for:
UT20UT30
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved