Camille Bauer SINEAX DM5000 Device Handbook

Also see for SINEAX AM3000: Operating instructions Operating instructions

Contents

Camille Bauer SINEAX DM5000 Device Handbook Manual pdf 36 page image

PM 1001484 000 08 Device handbook SINEAX DM5000 36/966.4.3 Connection of the IEC61850 interfaceThe RJ45 sockets X1 and X2 serve for direct connecting Ethernet cables. Both ports are equivalent andinternally connected via a switch. Interface: RJ45 sockets, Ethernet 100BaseTX Mode: 10/100 MBit/s, full / half duplex, Auto-negotiation Protocols: IEC61850, NTPFunctionality of the LED's• LED green: On if a network connection (link) exists, flashes during communication6.4.4 Connection of the PROFINET interfaceThe RJ45 sockets X1 and X2 serve for direct connecting Ethernet cables. Both ports are equivalent andinternally connected via a switch.Note: The interface may only be connected to a local Profinet network, which is designed as SELV circuitaccording to IEC 60950-1. Interface: RJ45 sockets, Ethernet 100BaseTX Mode: 10/100 MBit/s, full / half duplex, auto-negotiation Protocols: PROFINET, LLDP, SNMPFunctionality of the LED'sLED State MeaningX1 greenX2 greenOFF No network connectionON Existing network connectionFlashing Active communicationRed leftBF (Bus failure)OFF No errorON No configuration, slow or no linkFlashing (2 Hz) No data exchangeRed rightSF (System failure)OFF No errorON Watchdog timeout, diagnosis active; System failureFlashing (1 Hz, 3s) DCP signal service via bus initiated