Installation Guide for RFU-D-HPPage 70 of 1792+0 Dual Polarization Remote MountThis procedure is for use with Interface antennas, up to six feet.For standard interface antennas (six feet and larger), no OMT and no Circ./Circ. Adaptor are used, and the flexiblewaveguides are connected directly to the antenna flanges. For instructions how to connect the waveguides to theantenna flanges, refer to the antenna vendor's documentation.Note:This procedure can also be used for 1+0 DP HW ready for 2+0 DP configurations.List of ItemsItemDescriptionQuantityMarketing Model1 RFU-D-HP RadioUnit1 See Section 0,Note!Refer to the product roadmap for availability of RFU-D-HP in a specific band, as well as theavailability of any specific mediation device.Presenting a specific component in this manual does not indicate that it is available for orderinPlease consult with your pre-sales engineer for specific component availability information.Radio Unit2 RFU-D-HPDiplexerUnit1 See Section Chapter 0, Diplexer Unit3 RFU-D-HP OMTKit1 DXDH-MD-OMT-ff4 FlexibleWaveguide Kit2
