Installation Guide for RFU-D-HPPage 58 of 1793 Insert the CAT-5e or CAT-6 cable into the gland body.Connection of CAT-5e or CAT-6 Cable to RFU-D-HPTo connect the CAT-5e or CAT-6 cable to the RFU-D-HP:1 Remove the relevant cap from the RFU-D-HP radio. You can use the side of the gland to unscrew thecap.2 Connect the cable to the RFU-D-HP.3 Screw the gland into the radio unit.Important Note! Before tightening the gland, make sure the gland is even with the cover. Tightenthe gland gently and make sure there is no resistance. If there is resistance, stop immediately andverify that the gland is not being inserted at an angle. Tightening the gland at an angle can ruin thethread on the gland and prevent proper sealing of the interface.4 Tighten the gland cap.5 Secure the cable to the gland using a tie wrap.
