Installation Guide for RFU-D-HPPage 57 of 17911 Crimp the RJ45 plug with the crimp tool. Make sure the twisted shield is crimped firmly to the RJ45 plug.12 Verify that the wires ended up the correct order and that the wires extend to the front of the RJ45 plugand make good contact with the metal contacts in the RJ45 plug.13 Push back the CAT-5e or CAT-6 plug cover on the connector plug.Note: It is recommended that the newly prepared cable be tested with a Cable Analyzersuch as the FLUKE DTX-1800 (or the equivalent), to make sure the cable complies with ANSI/TIA/EIA-568-B-2. Make sure to verify both connectivity and grounding continuity at both ends of the cable.Preparing the CAT-5e or CAT-6 Data Cable Already AssembledTo prepare the CAT-5e or CAT-6 cable already assembled:1 Release the gland cap and the gland rubber slightly.2 Insert the CAT-5e or CAT-6 cable into the gland cap and into the rubber gland.
