Cal Flame BBQ08873P Owner's Manual

Cal Flame BBQ08873P Owner's Manual Manual pdf 25 page image

2010 Barbecue GrillsLTR20101038, Rev. AAppendixwww.calflamebbq.com23AppendixTroubleshootingProblem: Smell of gas is presentSolution: Check for loose connections in the gas line. Perform a leak test following the proceduredescribed in this manual.Problem: Burner does not igniteSolution: Note: Turn off the gas at the source while troubleshooting.Use the following procedure with the figure below.Check the position of the sparker tip. It should be pointing forward towards the front ofthe burner.Make sure there is a blue spark at the electrode tip to the burner.•Make sure the igniter wire is connected firmly to the valve ignition device and the•electrode.Make sure the valve orifice is free of any debris, dust or grease.•Make sure the valve orifice is aligned inside the front hole of the burner.•If there is no spark at all, replace the electrode or igniter wire.•Problem: Burner tube is misaligned over the orificeSolution: Reposition the burner tube so that it is properly seated over the orifice.Problem: Obstruction in the gas lineSolution: Remove the fuel line from grill. (Do not smoke or perform any maintenance in the vicinityof an open flame.) Open the gas valve for one second to blow out any debris. Close offthe gas valve and reconnect the fuel line securely. Let the area ventilate for a few secondsbefore reconnecting the fuel line.