AVALON Gourmet rev. 7 2013/04www.cafection.com (800) 561-61628INSTALLATION AND SERVICE MANUAL for AVALON Gourmet Initial Setup3 INITIAL SETUPBefore you install the brewer on location, we strongly suggest that it be unpacked, inspected and benchtested before it leaves your warehouse.3.1 On-site installation requirements3.1.1 Operating environmentFor indoor use only.3.1.2 Power supplyMake sure each unit has its own electrical circuit and is located within 6 feet of the dedicated electricaloutlet.Use only a polarized grounded receptacle.Domestic 115 VAC / 60 Hz - 15 A Circuit.3.1.3 Water supplyShould be a plastic 1/4” or 3/8’’ O.D. dedicated line branched off a larger line. An easily accessible shutoff valve up stream of the unit is highly recommended for ease of installation. Water pressure should be atleast 20 PSI and no more than 80 PSI3.1.4 Tools required#2 Phillips screwdriverRegular medium pliersAdjustable wrenchLevel indicatorOther tools may be required depending on the type of water supplytubing and location.3.1.5 ClearancesMachine Clearance Necessary for :Height 44” 50” Opening the top of the machine.Width 18 1/2” 26” Per side. Key access on one side and door swing onthe other.Depth 26” 26 1/2” In front when the door is open.Otherclearance1.5”6”Clearance of water hookup, hoses and adequate aircirculationNeeded only if a filtration system is installed behind themachineSee footprint and waste chute position in annex 4 and 5.