Black plate (49,1)Cadillac Escalade/Escalade ESV Owner Manual - 2010Compass CalibrationThe compass can be manually calibrated. Only calibratethe compass in a magnetically clean and safe location,such as an open parking lot, where driving the vehiclein circles is not a danger. It is suggested to calibrateaway from tall buildings, utility wires, manhole covers,or other industrial structures, if possible.If CAL should ever appear in the DIC display, thecompass should be calibrated.If the DIC display does not show a heading, forexample, N for North, or the heading does not changeafter making turns, there may be a strong magnetic fieldinterfering with the compass. Such interference may becaused by a magnetic CB or cell phone antenna mount,a magnetic emergency light, magnetic note pad holder,or any other magnetic item. Turn off the vehicle, movethe magnetic item, then turn on the vehicle and calibratethe compass.To calibrate the compass, use the following procedure:Compass Calibration Procedure1. Before calibrating the compass, make sure thecompass zone is set to the variance zone in whichthe vehicle is located. See “Compass Variance(Zone) Procedure” earlier in this section.Do not operate any switches such as window,sunroof, climate controls, seats, etc. during thecalibration procedure.2. Press the vehicle information button untilPRESS V TO CALIBRATE COMPASS displays.3. Press the set/reset button to start the compasscalibration.4. The DIC will display CALIBRATING: DRIVE INCIRCLES. Drive the vehicle in tight circles at lessthan 5 mph (8 km/h) to complete the calibration.The DIC will display CALIBRATION COMPLETEfor a few seconds when the calibration is complete.The DIC display will then return to theprevious menu.DIC Warnings and MessagesMessages are displayed on the DIC to notify the driverthat the status of the vehicle has changed and thatsome action may be needed by the driver to correct thecondition. Multiple messages may appear one afteranother.Some messages may not require immediate action, butyou can press any of the DIC buttons on the instrumentpanel to acknowledge that you received the messagesand to clear them from the display.Some messages cannot be cleared from the DICdisplay because they are more urgent. Thesemessages require action before they can be cleared.4-49
