Cadel Martina Installation, Use And Maintenance Manual

Also see for Alessia: Installation, use and maintenance handbook

Cadel Martina Installation, Use And Maintenance Manual Manual pdf 19 page image

19MARTINA - VANESSA - ALESSIA - SOLARISENPANEL ELEMENT DESCRIZIONEThermostat: activatedFlashing: during the temperature set or when inside the menuDisplay A During the starting up shows the mother board state. During the running shows theheating power. During the setting shows the parameters in modificationDisplay BDuring the starting up shows the mother board state. During the working phase showsthe temperature set by the user. During parameters modification shows the value ofthe parameter in modification.Fig. 21 - LED control displayLEGEND Fig. 21 page 191 Display A: state, power (name of the parameter)2 Display B: state, time, temperature (size value)10.4 IGNITIONWe remind you that the first ignition must be executed by authorized and skilled technical personnel who checksthat all is installed in compliance with current regulations and verifies stove’s efficiency.• If inside the combustion chamber there are booklets, manuals, etc.… please remove them.• Check that the door is correctly closed.• Check that the plug is correctly put into the electric socket.• Before switching the stove on, please assure you that the burning pot is cleaned.• To start the stove up, keep pressed P4 key for an instant till the display shows “FAN CAND”: the preheatingof the ignition plug starts. After 2 minutes about, the display will show “LOAD WOOD”: now the auger loadthe pellet and the preheating of the ignition plug continues. When the temperature is suffuciently high (afterabout 7-10 minutes), the ignition is considered as occured and the display shows “FIRE ON”.• When the “FIRE ON” phase has finished, the control unit enters in working mode and the selected calorificpower and the ambient temperature will be shown. It is in this phase that P5 and P6 are useful for regulatingthe stove power from 1 to 5.10.5 FLAME ADJUSTMENTIt is possible to regulate the flame thanks to the PVC lid applied to the combustion air inlet pipe which stands onthe back side of the stove.• If the flame is weak and the glass tends to blackens, this means that the combustion is not correct: it isnecessary to open the regulator (see Fig. 22 page 20).