CAME Frog-A 24U Installation Manual

Also see for Frog-A 24U: Installation manual

Contents

CAME Frog-A 24U Installation Manual Manual pdf 17 page image

16WIRE THE ENTRAPMENT PROTECTION DEVICESWIRINGWIRE THE ENTRAPMENT PROTECTIONDEVICESEDGE SENSORS (CONTACT)An entrapment protection devices such as photoelectric sensors or an edge MUST bewired to the operator and then configured for your application using theprogramming menu. Refer to page 18 - page 21 for programming information.Configure either CX, CY, or CZ (N.C.) contacts.C7 “OPEN WHILE CLOSING” (N.C.) ContactThis input functions to reverse the gate to the open limit when activated during theclose cycle.NOTE: If not used, deactivate.C8 “CLOSE WHILE OPENING” (N.C.) ContactThis input functions to reverse the gate to the close limit when the edge is activatedduring the opening cycle.NOTE: If not used, deactivate.C NO NCTwo-wire normally open edgeWireless CommunicatorTransmitter24V CPWR Relay Receiver