Bosch Security System User Manual

Contents

Security System | User's Guide | Part I: Security System Basics - Burglary AlarmsBurglary AlarmsBurglary alarms are the second priority. When a burglarypoint activates while your system is armed, your keypad emitsa steady high-pitched burglary tone. The tone sounds for thetime set by your security company.The keypad display shows the number of burglary pointsactivated, the message Enter Passcode + ENTER key toSilence” and then custom text for each activated pointIf there is more than one point causing an alarm, the displaywill show each point for three seconds before showing thenext one. When the last alarm is shown, the next display is thefirst one.Silencing Burglary AlarmsEntering a personal passcode with the proper authority levelsilences a burglary alarm and disarms the system if it wasarmed.The system will now display *Alarm Silenced* and then thenumber of points in alarm (### ALARMS) and the customtext of all the points in alarm, in the order of occurrence willdisplay.Entering COMMAND 4 clears the scrolling point text fromthe display.The *Alarm Silenced* message will continue to alternatewith idle text as a reminder that it is still possible to view thetext of the points in alarm by using the View Memoryfunction (refer to VIEW MEMORY ? (COMMAND + 4 + 0) onpage 43) for more information.To clear the event memory and remove the *AlarmSilenced* message from the display, press the ClearDisplay> soft key.The display will show the instructions for clearing themessage. Enter a valid passcode and press the Clear> softkey.