Bosch SPV68U5 Installation Instructions Manual

Also see for 800 Series: Installation instructions Service manual Quick start and safety guide Use and care manual Installation instructions

8Figure 8To connect the hot water supply:1. Assemble the water supply adaptor fitting (PartF) from the parts bag onto the dishwasher watersupply hose. This connection does not requireTeflon brand tape.2. Pass the dishwasher water supply line withattached adaptor through the opening toward thewater shut off valve. Take care not to allow thehose to kink or twist behind the dishwasher.3. Connect the dishwasher water supply line withadaptor to the water shut off valve. You will needto use an approved dishwasher water supply linewith the correct fittings for this connection.Always use the appropriate seal when makingplumbing connections.NOTE: The end of the dishwasher water inlet hose isheavy and will need to be supported. It is best to laythe end on the cabinet floor as shown in Figure 8.4. After all connections are made, turn on the hotwater and check for leaks.Drain ConnectionsThe dishwasher drain hose may be connected tothe house-hold or field drain plumbing in one of fourways. You will need an 11/4" diameter hole in orderto pass the drain hose through the cabinet. Youmay use the previously removed drain hose clip tohold the drain hose as shown in Figure 9 if needed.Figure 91. Directly under the sink dishwasher drainconnection, as shown in Figure 10.2. Directly to a disposer dishwasher drainconnection, as shown in Figure 11.3. To the under sink dishwasher drain connectionthrough an air gap, as shown in Figure 12.4. To a disposer dishwasher drain connectionthrough an air gap, as shown on Figure 13.IMPORTANT NOTES:x If local ordinance require an air gap, install itaccording to the manufacturer’s instructions.x If the dishwasher drain hose is to be connectedto a disposer dishwasher drain connection,remove the plug from the disposer’s dishwasherdrain connection.x The dishwasher drain hose must have one placealong its length that is securely attached 20Ǝ (508mm) above the cabinet floor.x The drain hose length can be extended ifnecessary. The maximum length of the drainhose, including the hose leading to the air gap, is150Ǝ (3800 mm).Figure 10 Figure 11Figure 12 Figure 13