Bosch LTC 8600 Instruction Manual

Also see for LTC 8557 Series: Instruction manual Instruction manual

Contents

LTC 8600 | LTC 8800 Series en | 81F.01U.127.393 | 2.0 | 2009.03 Instruction Manual Bosch Security Systems, Inc.diately be overridden by operators at the satellite location having any prioritylevel. This situation is more likely to be encountered in 3-tier satellite systemsthat do not have a good distribution of trunk lines (i.e., more between the toplevel system and the intermediate level system than there are between the inter-mediate system and the 3rd tier satellite).Since dual master configurations support bi-directional communications,selecting the SAT nnn PRIORITY option for both the top level and intermediatelevel master systems will result in the generation of priority based satellite com-mands.The satellite number assigned to the system that is currently being programmedmust be specified for the nnn value. This feature will enable use of the opera-tor's user priority to determine if access to a desired satellite camera is pro-vided or not. For instance, if no trunk lines are available and an operatorrequesting a satellite camera has higher priority than at least 1 of the existingoperators, the requested camera will be switched. If the operator does not havesufficient priority, they will receive an error message (i.e., error 81) via the sat-ellite communication path, and their camera will switch to the start-up cameraspecified in the Monitor Table.In addition, the same behavior for selecting trunk lines as described in the NOREM CAM CACHE option is applicable to this option. An operator's monitor willuse the same trunk from the same bay as different cameras are selected, aslong as no other operator is viewing the same satellite camera.User Function 42 - Keyboard Log-in Auto-off ModePriority 1 users can use this function to select a keyboard log-off feature to automat-ically log a keyboard off after a pre-selected time of inactivity. After entering themode, move the joystick up or down to select the desired time period. Enter a validpassword, and press [Enter]. If using the LTC 8555 keyboard, press [User] to exit themode.User Function 43 - CPU Battery StatusUse this function to view the condition of the batteries used to backup CPU mem-ory. Once the function is entered, the condition is displayed on the monitor text dis-play. If using the LTC 8555 keyboard, press [User] to exit the mode.User Function 44 – Camera Vertical Phase SetNOTE: This feature requires the following:1. LTC 8621 or LTC 8821 video input modules having firmware 5.30 or later.2. Dinion series of cameras using Bilinx communications.3. AutoDome series of cameras using either Bilinx or Biphase data communica-tions.4. LTC 8016/90 Bilinx Data Interface unit having firmware 1.01 or later.5. All cameras configured to use Line Lock mode.Priority 1 users can use this function to automatically adjust the phase intervaldelay of compatible cameras connected to the system. This will result in roll-freeswitching as the cameras are manually selected or automatically sequenced on sys-tem monitors.After entering the function, the joystick down/up is used to select either an individ-ual camera to adjust or all cameras. Enter a valid user password number and press[Enter] to activate the adjustment process.