108 | en LTC 8600 | LTC 8800 SeriesBosch Security Systems, Inc. Instruction Manual F.01U.127.393 | 2.0 | 2009.03Figure 22: Possible Allegiant Satellite System ConfigurationsAny Allegiant Series switcher model (LTC 8100, LTC 8200, LTC 8300, LTC 8500, LTC8600, LTC 8800, or LTC 8900) can be used as a main site or a satellite site unit. Allproducts are standard models, and the only special requirement is to use either theoptional LTC 8059/00 MCS or the optional LTC 8850/00 GUI Software package forinitial programming of each Allegiant system.An Allegiant biphase control data line from the code distribution unit at the Mainsite must be provided to each satellite site. This data line carries all pan/tilt/zoomcontrol commands, in addition to the switching commands generated by the Mainsite switcher. The control data line should be connected to a LTC 8780 Series DataConverter to provide address decoding functions for the satellite site. If operatorsat the satellite site are permitted to control pan/tilt/zoom-equipped cameras, aAllegiantSatelliteAllegiantSatelliteAllegiantSatelliteAllegiantSatelliteAllegiantMasterAllegiantMasterAllegiantMasterAllegiantMasterAllegiantMasterAllegiantSatelliteAllegiantMasterAllegiantSatellite/MasterAllegiantMasterAllegiantMasterTypical Master/Multiple Satellite ConfigurationDual Master ConfigurationQuadruple Master ConfigurationAll Masterscan view/con-trol all cam-erasSatellitecanview/controlonly localcamerasMaster canview /controlall camerasBothMasterscan view/control allcamerasSatellite can view/control only localcameras‘Cascaded’ Satellite ConfigurationSatellite/Master can view/control local and Satellite’s cameras
