Bosch C 80 Manual

Project Configuration | 9Bosch Motorsport Manual_C_80 39 / 1449.6 Timer ModuleThe Timer Module is designed to implement timing triggers, i.e. for rallye stage timing orminimum pit time calculations. Any event in the system can be used for starting, stoppingand resetting the timer.Up counting mode and down counting mode are available, triggers are fired at set time(up counting) or at zero (down counting). The running timer will keep its state over apower cycle.The output channels for this module depend on the name used for the module and arecalled …_time and …_trig.Measurement label Functionname_time actual timer valuename_trig trigger set by timer alarmIn this example, the module is named “Timer_Module”. Resulting channels are:9.7 GPS Trigger ModuleThe GPS Trigger Module triggers depending on GPS-position, similar to the GPS-laptrig-ger. There are 2 x 10 GPS trigger points available, 10 in the parameter and 10 in themacro-based mode.If the car passes one of the trigger points, an output signal is set to 1 shortly. Each triggerrequires a defined latitude, longitude and detection range.