Bosch AEC‑AMC2‑UL01 Installation Manual

Also see for AEC-AMC2-UL01: Installation manual

14 en | Connections AMC2 enclosure with 1DIN rail2020-07 | V04 | F.01U.330.018 Bosch Security Systems B.V.Mounting and connecting the power cable with LED indicator(G)Notice!Use this cable (G) instead of cable F if you are installing asystem that is to be UL approved.1. Pass the cable end through the front of the LED brackethole (Figure 1, position 12).2. Carefully pull the cable through the back of the LEDbracket.3. Make sure that the LED reaches and fits the LED brackethole.4. Connect the single brown wire to position 3, marked with L(Figure 3.2).5. Connect the other end from the brown wire to position 1,marked with L1 (Figure 3.2).6. Connect the single blue wire to the position 4, marked with N(Figure 3.2).7. Connect the other end from the blue wire to the position 2,marked with N ( Figure 3.2).Connecting the tamper contact (E)1. Mount the micro switch with two screws M2 x 10 mm(Figure 1.1, position 6) at the right side of the enclosure.2. Connect the loose ends of the tamper contact cable to thetwo-pin screw connector (marked with T) at the top of theAMC2.3. Position the cable in the space between the housing andthe mounting rail.Danger!Risk of electric shockMake sure that all wires have zero potential.