Black & Decker BDL220S Instruction Manual

Also see for BDL220S: Instructions User manual

Contents

WARNING: Read and understand all instructions. Failure to follow all instructions listedbelow may result in electric shock, fire and/or serious personal injury.SAVE THESE INSTRUCTIONSSafety InstructionsDANGER: Laser Radiation, avoid direct eye exposure, serious eye injury can result.• Do not use optical tools such as a telescope or transit to view the laser beam.• Do not place the laser in a position which may cause anyone to intentionally orunintentionally stare into the laser beam. Serious eye injury could result• Do not operate the laser around children or allow children to operate the laser.• WARNING: DO NOT DISASSEMBLE THE LASER. There are no user serviceable partsinside. Disassembling the Laser will void all warranties on the product. Do not modify theproduct in any way. Modifying the tool may result in Hazardous Laser Radiation Exposure.WARNING: Use of controls or adjustments or performance of procedures other than thosespecified in this manual may result in hazardous laser radiation exposure.• Do not operate in explosive atmospheres, such as in the presence of flammable liquids,gases, or dust.• Use only with the specifically designated batteries. Use of any other batteries may create arisk of fire.• Store idle product out of reach of children and other untrained persons. Lasers aredangerous in the hands of untrained users.• Use only accessories that are recommended by the manufacturer for your model.Accessories that may be suitable for one laser, may create a risk of injury when used onanother laser.• Repairs and servicing MUST be performed by a qualified repair facility. Repairs performedby unqualified personnel could result in serious injury.• Do not remove or deface warning labels. Removing labels increases the risk of exposure toradiation.• Turn the laser off when it is not in use. Leaving the laser on increases the risk of staring intothe laser beam.• Position the laser securely. Damage to the laser or injury could result if the laser falls.• For indoor use only.• This product is intended for use in a temperature range of 50° F (10° C) - 104° F (40° C)."CAUTION: Use caution when drilling, nailing or cutting into walls, floors and ceilings whichmay contain electrical wiring or pipes. Always turn off the power when working nearelectrical wires.VEA EL ESPAÑOL EN LA CONTRAPORTADA.INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA DE GARANTÍA.ADVERTENCIA: LÉASE ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO.INSTRUCTION MANUALCatalog No. BDL220SLL aa ss ee rr LL ee vv ee llCat No BDL220S Form # 90559839 JAN. 2010Copyright © 2010 Black & Decker Printed in ChinaCAUTION - CLASS 2 LASERRADIATION WHEN OPEN, DONOT STARE INTO THE BEAM.PRECAUCIÓN - RADIACIÓN LÁSERDE CLASE 2 - CUANDO ABRA, NOFIJE SU SU VISTA EN EL RAYO.FEATURESA.) Drywall PinB.) Protractor RingC.) Laser On/Off SwitchD.) Battery CompartmentCoverE.) Magnetic BaseF.) Vertical Bubble VialG.) Horizontal BubbleVialH.) Laser LineI.) Alignment IndicatorAHGB1First Aid Measures for Bubble Vial ContentIn case of skin contact, flush with soap and water. In case of eye contact, flush with flowing water.If swallowed, get medical help. Material Safety Data Sheet (MSDS) available from 1-800-544-6986.The label on your tool may include the following symbols:V ..........................volts mW......................milliwattsnm ........................wavelength in nanometers IIa ........................Class IIa LaserInstalling the BatteriesEnsure laser on/off switch (D) is in the full off position by moving switch actuator to "O"position. Remove the battery compartment cover (E). Insert 2 fresh 1.5 volt AA alkaline orheavy duty batteries making sure to match (+) and (-) terminals correctly. Replace batterycompartment cover.WARNING: Batteries can explode, or leak, and can cause injury or fire.To reduce this risk:• Carefully follow all instructions and warnings on the battery label and package.• Always insert battery correctly with regard to polarity (+ and -), marked on the battery and theequipment.• Do not short battery terminals.• Do not charge battery.• Remove dead battery immediately and dispose of per local codes.• Do not dispose of battery in fire.• Keep batteries out of reach of children.• Remove battery if the device will not be used for several months.“Transporting batteries can possibly cause fires if the battery terminals inadvertentlycome in contact with conductive materials such as keys, coins, hand tools and the like.The US Department of Transportation Hazardous Material Regulations (HMR) actuallyprohibit transporting batteries in commerce or on airplanes (i.e. packed in suitcases andcarryon luggage) UNLESS they are properly protected from short circuits. So whentransporting individual batteries, make sure that the battery terminals are protected andwell insulated from materials that could contact them and cause a short circuit.”Operating InstructionsDrywall PinCAUTION: Pin is sharp and should be handled with care.NOTE: The drywall pin (A) can only be used for drywall, NOT other surfaces includingplaster.• To press pin into drywall, first expose pin by rotating pin base from opposite side.• While maintaining pressure on pin base, insert pin straight and seat firmly against drywallsurface as shown in Figure 1. The drywall pin should always be pushed in by hand andnever driven by a hammer.• To remove drywall pin from the wall, pull out straight.CAUTION: Always be sure drywall pin is closed when not in use.Avoid exposure-Laser radiationemitted from this aperture.COMPLIES WITH 21CFR PARTS 1040.10 AND1040.11 EXCEPT FOR DEVIATIONS PURSUANTTO LASER NOTICE NO.50, DATED JULY 26,2001.LISTED406AWARNING / ADVERTENCIAAVERTISSEMENTBDL220S Type 1 3V DCTo reduce the risk of injury, user must read andunderstand instruction manual. Para reducir elriesgo delesiones, el usuario debe leer y entenderel manual de instrucciones.À titre préventif, lire le guide.Questions?: 1-800-54-HOW-TO Made in ChinaBlack & Decker (U.S.) Inc., Towson, MD 21286 U.S.A.CAUTION - CLASS 2 LASERRADIATION WHEN OPEN, DONOT STARE INTO THE BEAM.PRECAUCIÓN - RADIACIÓN LÁSERDE CLASE 2 - CUANDO ABRA, NOFIJE SU SU VISTA EN EL RAYO.3CDEFÉviter toute exposition aurayonnement laser émis par cetteouverture.For your convenience and safety, the following labels are on your laser.Pour plus de commodité et de sécurité, les étiquettes suivantes sont apposées sur votre laser.Para su comodidad y seguridad, el láser incluye las siguientes etiquetas:Evite la exposición - Por esteorificio se emite la radiaciónláser.IThank you for choosing Black & Decker!Go to www.BlackandDecker.com/NewOwnerto register your new product.PLEASE READ BEFORE RETURNING THISPRODUCT FOR ANY REASON:If you have a question or experience a problem with your Black & Decker purchase, go toHTTP://WWW.BLACKANDDECKER.COM/INSTANTANSWERSIf you can’t find the answer or do not have access to the internet,call 1-800-544-6986 from 8 a.m. to 5 p.m. EST Mon. -- Fri. to speak with an agent.Please have the catalog number available when you call.for instant answers 24 hours a day.SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE.

/ 4

Related manuals for Black & Decker BDL220S