Batco FX1535FL Operator's Manual

Batco FX1535FL Operator's Manual Manual pdf 34 page image

34 P1512120 R3Failure to warm the hydraulic oil can damage the pump or other components.When Operation of the Mover Kit is Complete:1. Secure the mover kit axle to the conveyor when operation is complete or before transporting.2. Fully disengage the over-center handles and secure the handle with the attached pin, see Figure 11 on page34.Do not transport with the over-center handles engaged or damage to the mover kit motorswill occur.Figure 11. Chain Position3. Disengage the pump to take the strain off the conveyor drive components.Ensure that the over-center bolts are tight enough to prevent the handle from engaging. Ifthey are not tight enough, damage to the gears and motor will result.4.4. Hand Winch OperationÆWhen equipped with a Hand Winch:Before using the hand winch, ensure that:• the cable anchor on the winch drum is tight.• all cable clamps are secure.• the lift cable is seated in cable pulley.• the cable is in good condition, if damaged, replace it immediately.• there is a minimum of 3 cable wraps on the winch drum when the conveyor fully lowered.To operate:1. Turn the winch handle to raise and lower the conveyor. The winch must make a clicking sound when raisingthe conveyor. If clicking sound stops, retain grip on handle, lower the conveyor fully and repair winch.4. PLACEMENT PORTABLE GRAIN BELT CONVEYOR – S-DRIVE FIELD LOADER