R5906150 /02 XDL365 6 7 X2Image 3-2Caution: Ensure that the pedestal is capable to carry the weight of the projector.After unpacking, allow the projector to acclimatize to a room temperature ranging from 10°C (50°F)to 35 °C (95 °F) MAX. Neglecting this may result in a start up failure of the Light Processor Unit.3.3 Initial inspectionGeneralBefore shipment, the projector was inspected and found to be free of mechanical and electrical defects. Assoon as the projector is unpacked, inspect for any damage that may have occurred in transit. Save all packingmaterial until the inspection is completed. If damage is found, file claim with carrier immediately. The BarcoSales and Service office should be notified as soon as possible.The packaging of the XDL projector is provided with a shock-watch label. If this shock-watch labelwas triggered (red colored at arrival) during transport may indicate rough handling by the transportcompany. In this case, the instructions mentioned on the label, should be followed, which are:adding a note on the “bill of lading” and informing the transport company and the Barco sales andservice office as soon as possible.Box content• Projector.• User and installation manual (this document).• Safety manual.The projector lens is not included in the package of the projector.Mechanical checkThis check should confirm that there are no broken knobs or connectors, that the cabinet and panel surfacesare free of dents and scratches, and that the operating panel is not scratched or cracked. The Barco Salesand Service office should be notified as soon as possible if this is not the case.Installation preparations
