DP2K-E seriesSafety manualR5906695/0019/06/2015

general considerations

important safety instructions

product safety labels

Barco DP2K-E series Safety Manual

DP2K-E series

software license agreement

Welcome

About this manual

Safety

General considerations

Important safety instructions

Product safety labels

Light beam Hazard Distance (HD)

HD in function of the lens Throw Ratio (TR)

Getting started

Installation requirements

Unpacking the projector

Initial inspection

Installation process

Installation process overview

Physical installation

Positioning the DP2K-E series projector at port window

projector tilting

Connecting the projector with the power net

Connecting a UPS to the projector electronics

Lenses & Lens selection

Available lenses

Lens selection

Lens installation

Lens removal

Lens shift, zoom & focus

Input & Communication

Introduction

Local Keypad

Projector Status

Cinema Controller

ICMP

ICMP introduction

ICMP HDD

ICMP communication ports

ICMP source input ports

ICMP reset button and status LEDs

ICMP HDD status LEDs

ICMP device certiﬁcate

ICMP conﬁguration via Communicator

Obtaining the Barco ICMP certiﬁcate

Removing a HDD form the ICMP

Installing a HDD into the ICMP

Communicator Touch Panel

Installing the Touch Panel interface

Repositioning the Touch Panel interface

Starting up

Switching the DP2K-E series projector ON

Switching the DP2K-E series projector OFF

Scheimpﬂug

Scheimpﬂug introduction

Scheimpﬂug adjustment

Fixation of the Lens Holder front plate

Back Focal Length adjustment

Convergence

Convergence controls

Preparing for convergence adjustment

Converging the blue pattern onto the red pattern

Converging the green pattern onto the red pattern

Closing off the Light Processor compartment

Lamp House

Removal of the Lamp Module

Installation of the Lamp House

Resetting the lamp parameters

Preventative maintenance actions

month maintenance actions

Maintenance procedures

Check the dust ﬁlters

Vacuum cleaning of the dust ﬁlters

Washing and drying the dust ﬁlters

Cleaning the lens

Cleaning the exterior of the projector

Authorization to clear security warning on the projector

Removal and installation of the projector covers

Removal of the front cover

Removal of the rear cover

Removal of the top cover

Removal of the left side cover

Removal of the right side cover

Removal of the top cover plate of the Light Processor compartment

Removal of the side cover plate of the Light Processor compartment

Installation of the side cover plate of the Light Processor compartment

Installation of the top cover plate of the Light Processor compartment

Installation of the right side cover

Installation of the left side cover

Installation of the top cover

Installation of the rear cover

Installation of the front cover

Speciﬁcations

Speciﬁcations of the DP2K-6E

specifications

Speciﬁcations of the ICMP

Dimensions of the DP2K-E series projector

Dimensions of the universal pedestal

Technical Regulations

Barco DP2K-E series Safety Manual

Product

Learn More

Legal


Contents general considerations important safety instructions product safety labels	DP2K-E seriesSafety manualR5906695/0019/06/2015 Next / 9