Barco DP2K-E series Safety Manual

Also see for DP2K-E series: User and installation manual Installation manual

Contents

Barco DP2K-E series Safety Manual Manual pdf 7 page image

1. Safety1.3 Product safety labelsProduct safety labelsLabel image Label description Label locationThe Lamp House is very hot after operation. To avoidburns, let the projector cool down for at least 15 minutesbefore proceeding to remove the Lamp House.General Warning HazardElectric Voltage HazardHot Surface HazardUV HazardHazardous moving parts.Keep away from moving fan blades.Keep fingers and other body parts away.On the fans inside the projector1.4 Light beam Hazard Distance (HD)HDLight beam Hazard Distance (HD) is the distance from the source at which the intensity or the energy per surface unitbecomes lower than the applicable safety limit. The light beam can thus be considered as dangerous if the operatoris closer from the source than the HD.Restriction Zone (RZ) based on the HDThe HD is defined from the projection lens surface towards the position of the lowest projected beam where the irradiance equalsthe applicable safety limit. The HD depends on the amount of lumens produced by the projector and the type of lens installed. Seenext chapter HD in function of the lens Throw Ratio (TR).To protect untrained users the installation shall comply with the following installation requirements: light output levels in excess of thelimits shall not be permitted at any point less than 2.0 meters (SH image 1-1) above any surface upon which persons are assumedto stand or 1 meter (SW image 1-1) below or in lateral separation from any place where such persons are assumed to be. Seeimage 1-1.R5906695 DP2K-E SERIES 19/06/2015 5

/ 9

Related manuals for Barco DP2K-E series