Menu
Barbeques Galore BVSR18 Owner's Manual
Also see for BVDR18: OWNER'S OPERATION AND INSTALLATION MANUAL
                        | |
901746-01D10LIGHTINGINSTRUCTIONSOPERATING APPLIANCEFOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not follow these instructionsexactly, a fire or explosion may result causing prop-erty damage, personal injury or loss of life.BEFORE LIGHTING smell all around the appliance area forgas. Be sure to smell next to the floor because some gas is heavierthan air and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; do not use any phone inyour building.• Immediately call your gas supplier from a neighbor’s phone.Follow the gas supplier’s instructions.• If you cannot reach your gas supplier, call the fire department.GAS SHUTOFFVALVE OPERATIONFlame AdjustmentAdjust the flame ON/OFF by turning the gas shutoff valvecounterclockwise to open or clockwise to close,as necessary.Shutting Off ApplianceTurn gas shutoff valve clockwise to the OFF position.During the 2-3 hour appliance break-in period, you may detectan odor from the appliance as the various paints and com-pounds used in the manufacturing of this log set cure. This is anormal and temporary situation that is not cause for alarm.However, you may want to provide extra ventilation to the roomduring this time.To ensure proper curing of the logs:• Ignite a 2" flame and maintain it for 1 hour.• Burn the logs in consecutive 1 hour periods raising the flamean additional 2" to full flame height for a total of three hours.CURING LOGS1. STOP! Read the safety information, above.2. Turn the gas shutoff valve to OFF.3. Wait five (5) minutes to clear out any gas. If you then smellgas STOP! Follow the safety information above. If you don'tsmell gas, go on to the next step.4. Light a match and lay it on top of the pan material about2" from the end of the supply side of the pan5. Slowly turn the gas shutoff valve ON until the burner ig-nites. If the burner doesn’t ignite within 10 seconds withthe match burning, turn the shut-off valve OFF and repeatsteps 1 through 4 again.WARNING: Keep flue open when operating unit.IgnitorControl KnobPilotFROM "P LOT" POSITIONSLIGHT PUSH TOTURN OFFPULL PUSHONONFROM "PILOT" POSITIONSLIGHT PUSH TOTURN OFFPULL PUSHFROM "PILOT" POS TIONSLIGHT PUSH TOTURN OFFPULL PUSHON OFFOn OffOFFOFFFigure 21 - Ignitor and Control KnobFigure 22 - Thermocouple and PilotPilotBurnerThermocoupleNote: Operation instructions for GA9150A Remote ReadyValve/Pilot Kit will be included with the kit.1. STOP! Read the safety information, column one, this page.2. Make sure equipment shutoff valve is fully open.3. Press in and turn control knob clockwise to theOFF position.4. Wait five (5) minutes to clear out any gas. Then smell forgas around log set and near floor. If you smell gas, STOP!Refer to the National Fuel Gas Codes, ANSI Z233.1/NFPA54, Section 5.3, Air for Combustion and Ventilation. If youdon’t smell gas, go to the next step.OPERATING INSTRUCTIONSFOR GA9050A-1OPERATING APPLIANCEFor Your Safety Read Before LightingLighting InstructionsGas Shut-Off Valve OperationCuring LogsOperating Instructions for GA9050A-1 |
Related manuals for Barbeques Galore BVDR18
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved