Ignition System Check1. Remove the spark plug and reattach it to the spark plug lead.2. Push the electric button “START “(yellow button). Apply the rear brakelever to make sure the rear wheels are locked. If the ignition system isoperating properly, a blue spark should jump across the spark plug gap.If there is no spark, take your machine to your service center.COMPLAINT: Engine stalls1. Make sure there is enough fuel in the fuel tank.2. Check to see that the spark plug is not fouled. Remove the spark plugand clean it. Replace it, if necessary.3. Make sure the fuel valve is not clogged, and the fuel tank is not clogged,either.4. Check the idle speed. If necessary, adjust it using a tachometer. Thecorrect idle speed is 1400~1600 r/min.WARNINGPerforming the spark test improperly could be hazardous.You could get a high voltage electrical shock if you are not familiar with thisprocedure.Do not perform this check if you are not familiar with the procedure. Donot point the spark plug near the spark plug hole during this test. Do notdo this test if you have a heart condition or wear a pacemaker. Do notperform this test near any open fuel containers for near fuel which hasspilled on the ground, on engine, or any part of the ATV.TROUBLESHOOTING