Battery Replacement:· Remove old battery. Mark which cable is connected to the positiveterminal (+) and which cable is connected to the negative (-) terminal.· Clean cable connectors with wire brush or sandpaper to removeoxidation.· After charging, install new battery. Put dielectric grease on the batteryterminals to avoid corrosion. Connect cables to the proper terminals.Positive (+) red cable to positive (+) terminal and negative (-) cable tonegative (-) terminal .· Positive (+) cable is red .Negative cable is black. CONNECT NEGATIVECABLE LAST.WARNING· DO NOT open sealed caps to add water to battery.· Always wear safety glasses and charge in a ventilated area.· If battery gets hot to the touch, discontinue charging and allowbattery tocool down.· Do not use fast charging unless it is an emergency.· At the beginning or end of charging, turn off the charger first, inorder to prevent electric spark and explosion.· Charge in a well ventilated area.· DO NOT smoke around batteries and keep away from open flame.WARNING· To avoid possibility of explosion, always connect battery cable inthe order specified: RED first; BLACK last. An exploding battery cancause serious injury or death.· Batteries contain sulfuric acid.· Always shield eyes with protective eyewear when working aroundbattery acid.· Battery acid is poisonous and can cause severe burns.· DO NOT smoke around batteries and keep away from open flame.INSPECTION AND MAINTENANCE