CHAPTER 2 – Safety informationChap. 2- 45/ 52 -2.16.8 Residual risks during SINGLE PITCH loading/unloading (work cycle)2.16.8.1 SINGLE PITCH loading/unloading (work cycle) – (Risk ID: 12.01)IDENTIFICATION RISK ASSESSMENTStage: UsePerson: OperatorArea: Z02 Material loading/unloading areaInitial risk: HIGHRESIDUAL RISK: LOWPLr (EN 13849): dSIL (EN IEC 62061): SIL2ACCIDENT SCENARIOConsequence: 1.3 CrushingSituation: Loading and unloading piece/s to/from the table.Event: Risk of crushing resulting from the closing of the piece support devices.Body part: Hands, fingers.RESIDUAL RISKRisk of crushing resulting from the closing of the piece support devices.LIMITATION MEASURESMechanical: During loading/unloading stages, two protection measures are implemented forreducing the risk and remedy to any misconducts by redundancy. These measuresare:- Adjusting of the piece support devices, carried out by the maintenance technicianduring machine setup.- Two different pressure values (PROTECTION MEASURE M10) duringloading/unloading and processing stages.Electrical: Check of the closing pressure of the piece support device.Informative: The closing of the piece support device is performed by pressing the specific pedalbutton located near the table. Once the piece has been put in place, keep thehands away from the piece support devices, then step on the pedal to effect theclosing, which occurs at a reduced force compared to that used during theprocessing cycle.The piece support devices must be exclusively adjusted by the maintenancetechnician in two different manners, described in the manual chapter on controlsand use.Symbols: -
