Baby Lock Momentum BLQM Assembly And Use Instruction Manual

Baby Lock Momentum BLQM Assembly And Use Instruction Manual Manual pdf 14 page image

Fig. 10-1-CFig. 10-2-CRail Ratcheting EndNon-Ratcheting End InsertIdler Rail Clamp Locking AssemblyIdler Clamp Floating InsertM6 Set ScrewsFig. 11-1-a Fig. 11-1-bFig. 11-2Hinge HingePage. 13Parts Needed:4- Rail Ratcheting End4- Rail Non-Ratcheting End1- Idler Rail Clamp LockingAssembly1- Idler Clamp Floating Assembly8 - M6 x 10mm Set Screws (Pre-installed in the Rail Couplers)Tools Required:3mm Allen Wrench4mm Allen Wrench6mm Allen Wrench10-1-C: Unfasten the Non-Ratcheting End Insert from a Rail Non-Ratcheting End with a 6mm Allen Wrench.Insert and fasten the Non-Ratcheting End Insert into the Rail Ratcheting End. (Fig. 10-1-C)Note: If the rail end is difficult to remove, loosen the bolt half way out. Push in the bolt to release the com-pression cone, which will allow the rail end to be easily removed.10-2-C: Repeat step 10-1-C for the remaining 3 rail ends.10-3-C: Unfasten the Idler Clamp Floating Insert from the Idler Clamp Floating Assembly by removing fourM6 Set Screws with an M3 Allen Wrench. Insert and Fasten the Idler Clamp Floating Insert into the Idler RailClamp Locking Assembly. Align the Clamp Rails so that the hinges are on the same side. (Fig. 10-2-C)Step: 10-C: Rail Assembly for CribParts Needed:1- Magnet Bracket1- Magnet Bracket Spacer1- 1/4 x 1 inch Hex BoltTools Required:1- 7/16 inch Wrench (Not provided with framecontents.)11-1-a: To install Precision Glide Wheels, remove thehex bolt from the rear right machine wheel. Align andfasten the Magnet Bracket Spacer and re-attach the hexbolt. (Fig. 11-1-a)11-1-b: When using Standard Wheels, remove thehex bolt from the rear right machine wheel. Align andfasten the Magnet Bracket Spacer, Magnet Bracket, and1/4 x 1 inch Hex Bolt provided with the hardware. (Fig.11-1-b)11-2: Place the Machine on the Bottom Carriage.(Fig. 9-3)Step 11: Machine Magnetic BracketPrecision Glide WheelsMagnet Bracket SpacerMagnet Bracket1/4 inch Hex Bolt (included)