Baby Lock Momentum BLQM Assembly And Use Instruction Manual

Baby Lock Momentum BLQM Assembly And Use Instruction Manual Manual pdf 10 page image

Fig. 5-1-CM6 Connector BoltM6 Plastic WasherFig. 5-2-CFront Rail Bracket Left Rail Holder EndFront Rail Bracket Right Ratchet EndM8 Nylock NutM8 x 50mm SBHCSFig. 6-2Rail Holding EndRatchet EndBack Track Assembly SidePlastic TrackBack Track SupportFront Track SupportFront Rail Bracket Left Rail HolderEndM8 x 16mm SBHCSFig. 6-1Page. 9Parts Needed:4- 5 ft Plastic TrackTools Required:4mm Allen Wrench5-1-C: Detach the pre-installed Track Supportfrom the Table Assembly by unfastening theM6 Connector Bolts with a 4mm Allen Wrench.(Fig. 5-1-C)5-2-C: Slide the 5 ft Plastic Track down thetrack grooves of the Track Support Assembly.(Fig. 5-2-C)5-3-C: Repeat step 5-2 to assemble the 5 ftFront Track Support Assembly.5-4-C: Loosely fasten the Front Track Assem-bly and securely fasten the Back Track Assem-bly onto the Table Assembly with ConnectorBolts and M6 Plastic Washer. The Rear TrackAssembly side should be flush with the backedge of the table. (Fig. 5-1)Note: The Front Track Assembly will be ad-justed and tightened in step 9.Parts Needed:1- Front Rail Bracket Right Ratchet End1- Front Rail Bracket Left Rail Holder End4- M8 x 50mm SBHCS4- M8 Nylock NutTools Required:5mm Allen WrenchOpen Wrench 13mm and 10mmNote: The bolt height may need to be adjusted after thesewing machine has been set on the frame so that fabriclays flat in the throat of the machine. This assembly stepis universal for both Crib and King size frames.6-1: Insert the Rail Brackets into the corresponding tubeends. (Fig. 6-2)Note: Loosen the M8 x 16mm SBHCS on the Rail Brack-ets if the brackets are a tight fit into frame ends.Step 5-C: Track Assembly for Crib Size FrameStep 6: Front Rail Bracket Assembly