4 SpaceLink Access PointFederal Communications Commission StatementThis device complies with FCC Rules Part 15. Operation is subject to the followingtwo conditions:• This device may not cause harmful interference, and• This device must accept any interference received, including interference thatmay cause undesired operation.This equipment has been tested and found to comply with the limits for a class Bdigital device, pursuant to Part 15 of the Federal Communications Commission (FCC)rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses, and canradiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to tryto correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.WARNING! The use of a shielded-type power cord is required inorder to meet FCC emission limits and to prevent interference tothe nearby radio and television reception. It is essential that onlythe supplied power cord be used. Use only shielded cables to con-nect I/O devices to this equipment. You are cautioned that changesor modifications not expressly approved by the party responsiblefor compliance could void your authority to operate the equipment.Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. WashingtonDC: Office of the Federal Register, National Archives and Records Administration,U.S. Government Printing Office.Canadian Department of CommunicationsThis digital apparatus does not exceed the Class B limits for radio noise emissionsfrom digital apparatus set out in the Radio Interference Regulations of the CanadianDepartment of Communications.This Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la normeNMB-003 du Canada.Safety Statements