Asus SpaceLink WL-300 User Manual

Also see for SpaceLink WL-300: Quick start guide

Chapter 1SpaceLink Access Point 17Chapter 1 - Introduction2. InstallationThis chapter describes the installation procedure for the SpaceLink AccessPoint and includes a description of the LEDs found on the unit.Installation ProcedureFollow these steps to install the SpaceLink Access Point.1. Determine the best location for the SpaceLink Access Point. Keep inmind the following considerations:• The length of the Ethernet cable that connects the Access Point tothe network must not exceed 100 meters.• For standard placement, try to place the Access Point on a flat, sturdysurface as far from the ground as possible, such as on top of a deskor bookcase, keeping clear of metal obstructions and away fromdirect sunlight.• For external antenna mounting, install the external antennas so thatthey are clear of obstructions; refer to the documentation that camewith the antennas for mounting and installation instructions.• Try to centrally locate the Access Point or its antennas so that it willprovide coverage to all of the wireless mobile devices in the area.• Use only the power supply that came with this unit. Other powersupplies may fit but the voltage and power may not be compatible.It is the responsibility of the installer and users of the SpaceLinkAccess Point to guarantee that the antenna is operated at least 20centimeters from any person. This is necessary to insure that theproduct is operated in accordance with the RF Guidelines for Hu-man Exposure which have been adopted by the Federal Communi-cations Commission.2. Place the Access Point in the desired location. Wall mounting is alsopossible for the Access Point. Refer to the section entitled “WallMounting Option” on the next page for details.3. Attach one end of an RJ-45 Ethernet cable to the Access Point andattach the other end to the RJ-45 10Base-T port of a network hub, switch,router, or patch panel (possibly on a wall).The SpaceLink Access Point does not support 100Base-TX; it onlysupports 10Base-T. Hubs or switches that supports both 10Base-Tand 100Base-TX may be used.