Appendix E Mounting Instructions163E.3 Desktop Stand MountingThe PPC-153 has a customized stand suitable for desktops and otherhorizontal locations. A unique spring inside the stand enables thepanel PC’s vertical tilt to be adjusted about 30 degrees. The stand isavailable from Advantech Co.Follow these procedures to set up the stand:1. Remove the rear cover of the panel PC by unscrewing the sevenscrews.2. Attach the holding plate of the stand to the inside of the rear coverof the panel PC using the five screws provided. (See Fig. E-4.)3. Reattach the rear cover of the panel PC.4. Attach the main body of the stand to the rear cover of the panel PCusing the four screws provided.5. Slide the main body of the stand into the stand base. Tighten itwith the two screws provided.6. Attach the rear cover of the stand to the main body of the stand bysnapping the lugs of the rear cover into the slots of the main body.When the rear cover locks into place, you will hear a click.7. Attach the top cover of the stand to the main body of the stand bysnapping the lugs of the top cover into the slots of the main body.The cover must be rotated as it is snapped into place. When thetop cover locks into place, you will hear a click.Note: The base of the stand has two plastic caps. If youpry off the caps, you can attach the stand to yourdesktop using the two screw holes.
