Adaptec Workstation x1000 Installation Manual

Also see for 2100S - SCSI RAID Controller: Installation guide Installation guide Quick start guide Software user's guide Installation guide

Contents

Adaptec Workstation x1000 Installation Manual Manual pdf 45 page image

3-7installing the driverd When you see the Adaptec splash screen, click CreateDriver Disk. Then, click the appropriate operatingsystem.e Insert a floppy disk and click OK. The system creates thedriver disk.4 Shut down the system and remove the Adaptec RAIDInstallation CD and the driver floppy disk.5 Insert the Windows NT setup media (floppy disk or CD) andrestart the system.6 If prompted, skip Setup’s mass storage detection. Press S toSpecify Additional Devices.7 Select Other, then insert the driver disk you created inStep 3.8 Select Adaptec I2 O RAID Host Adapter Driver forNT 4.0.9 Press Enter and continue with the installation as describedin the Windows NT documentation.installing the driver in a new system with otherhardwareIn this scenario, you are installing an Adaptec RAID controller ina new computer system with another controller from anothermanufacturer or other hardware that requires the use ofWindows NT mass storage detection. To install the driver1 Create a driver disk using the Adaptec RAID InstallationCD. To create a driver diska Insert the Adaptec RAID Installation CD in your drive.b Boot from the CD. The CD loads a Linux kernel that isused to manage all of its functions.c Follow instructions and respond to prompts as necessaryto get to the Adaptec splash screen.d When you see the Adaptec splash screen, click CreateDriver Disk. Then, click the appropriate operatingsystem.