Adaptec SCSI RAID 2100S Installation Manual

Also see for 2100S - SCSI RAID Controller: Installation guide Quick start guide Software user's guide Installation guide Installation guide

Contents

Adaptec SCSI RAID 2100S Installation Manual Manual pdf 46 page image

3-11Installing the DriverWindows 95, Windows 98, and Windows MeThe following installation scenarios are discussed: Installing the Driver in a New Windows 98/Me System on page 3-12 Installing the Driver in a New System with Windows 95 (OEM SR2– Version 95B) on page 3-14 Adding the Controller to an Existing Windows 95/98/Me System onpage 3-16 Upgrading Windows 95 to Windows 98/Me (Upgrade Version) onpage 3-18Creating the Driver DiskEach of the procedures for installing the driver in each case requiresa slightly different procedure. However, all the procedures requireyou to create a driver disk. To create the driver disk1 Insert the Adaptec RAID Installation CD in your drive.2 Boot from the CD. The CD loads a Linux kernel that is used tomanage all of its functions.3 Follow instructions and respond to prompts as necessary to getto the Adaptec splash screen.4 When you see the Adaptec splash screen, click Create DriverDisk. Then, click the appropriate operating system.5 Insert a floppy disk and click OK. The system creates thedriver disk.6 Shut down the system, and remove the Adaptec RAIDInstallation CD and the driver floppy disk.CD-ROM SupportBefore you can install Windows, you need to verify that you can useyour CD drive to install Windows. Identify the scenario that appliesto your situation and follow the recommendations below: If the CD drive plugs into the motherboard or is on an ATAcontroller, use the Windows startup floppy disk included withthe Windows CD.