Actron Elite AutoScanner CP9185 User Manual

Also see for CP9190: User manual

Contents

Actron Elite AutoScanner CP9185 User Manual Manual pdf 172 page image

IMPORT (OBD II) Diagnostics8 – 2 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •8❒ Review Data❒ Print Data•I/M Readiness•DTC (Codes)•Pending Codes•Freeze Frame•O2 Monitor Test•Diagnostic Monitor Tests•Vehicle Info•Playback•State OBD Check•Modules Present✓ The following stored infromation can be reviewed for Import vehi-cles. Refer to Review Data and Print Data in the Using the ScanTool section of this manual.– Code Lookup– Tool Setup menu– English/Metric– Display Contrast– Beeper– Setup User Key✓ If an Error Message displays, make sure the OBD II connector issecurely attached, and the ignition key is on. Cycle the ignition keyto off for 10 seconds, then on. This may be required to reset thecomputer. If required, select yes to try again. If the problem stillexists, refer to Error Messages on page 9-2.Diagnostic Codes MenuItems marked with “-” are covered in section 3 of thismanual. These items are not covered in this section.❒ Diagnostic Codes Menu❒ Read Codes– Pending Codes– Erase Codes– View Freeze Data– Code Lookup– Review Data– Print Data– Tool SetupIMPORTANT