Acorp 4D533 User Manual

Contents

Acorp 4D533 User Manual Manual pdf 21 page image

HAREWARE INSTALLATION2.2.7 Power LED ConnectionsSystem Function Connector Block (J6)☆ Pins [ 2 & 4 & 6 ] Power LED leadPins 2 & 4 & 6 connect to the power LED from the system's case.☆ Pins [ 3 & 4 & 5 & 6 ] SpeakerConnects to the Speaker lead from the systems case.☆ Pins [ 8 & 10 ] Suspend LED leadThis LED blinks to indicate the system is in suspend mode.☆ Pins [ 11 & 12 ] IDE Activity LEDHook the IDELED lead to this connector, with the RED lead corresponding to Pin-1.☆ Pins [ 13 & 14 ] Reset switch leadConnects to the Reset Switch lead from the system's case. The reset switch is used tocold-boot t the system without actually turning off the power, reducing wear and tear onthe power supply.☆ Pins [ 15 & 16 ] Soft Power SwitchConnects to the Power Switch featured on ATX case designs. This switch must behooked up before the system can be powered on.Note: Under the following two conditions, you have to press and hold the switch for longerthan4 seconds to power off your system, regardless of the Soft-Off by PWRBTN settingin the BIOS.■ Shortly after the system is powered on, when the BIOS message is not yet appear.■ When CPU hangs.User's Manual 21