Acorp 4D533 User Manual

Contents

Acorp 4D533 User Manual Manual pdf 20 page image

HAREWARE INSTALLATION2.2.5 Floppy DrivesThis connector supports the provided floppy drive ribbon cable. After Connecting one end tothe mainboard, connect the other end to the Floppy drive. (Pin 5 is removed to preventincorrect insertion when Using ribbon cables with pin 5 plug).Note: Make sure the RED stripe on the ribbon cable is oriented towards Pin-1.2.2.6 IDE Hard Drives and CD-ROMsThis connector support the provided UltraDMA/100/66 IDE hard disk Ribbon cable. Connectthe cable’s blue connector to the primary (recommended) or secondary IDE connector, thenconnect the gray connector to the UltraDMA/100/66 slave device (hard disk drive) and theblack connector to the ltraDMA/100/66 master device. It is recommended that you connectnon-UltraDMA/100/66 devices to the secondary IDE connector. If you install two hard disks,you must configure the second drive as a slave device by setting its jumper accordingly. Referto the hard disk documentation for the jumper settings. BIOS supports specific device boot up.If you have more than two UltraDMA/100/66 devices, purchase another UltraDMA/100/66cable. You may configure two hard disks to be both master devices with two ribbon cables –one for the primary IDE connector and another for the secondary IDE connector.Note: Make sure to align the RED stripe on the ribbon cable with Pin-1 on the mainboardIDE connector. On most hard drives and CD-ROMs, the RED stripe should beoriented towards the power connector of the deviceUser's Manual20